|
To install ComSwitch as shown, follow these steps:
| 1. |
Label one of the RJ11 jacks "#1" and
the other RJ11 "#2." |
| The RJ11 jacks have four (4) posts: the red
post is marked [R] the green post is marked [G], the black post is marked [B], and the
yellow post is marked [Y]. |
| 2. |
Locate the telephone line from the phone
company after it enters the premises but before it routes to any phone jack. |
| 3. |
With the utility knife, cut into the cable to
expose the red, green, black, and yellow wires. |
| If the color codes of the wires are not red,
green, black, and yellow, call Command Communications for further instructions. No phones
connected to line one should have dial tone. |
| 4. |
Cut the red and green wires and expose the
copper wire, while leaving the black and yellow wires intact. |
| 5. |
Connect the cut wires from the phone company
to jack "#1" by attaching the red wire to the red post and the green wire to the
green post. |
| 6. |
Connect the cut wires that feed all the phones
in the location to jack "#2" by attaching the red wire to the red post and the
green wire to the green post. |
| 7. |
Plug one end of a phone cable into jack
"#1." |
| 8. |
Plug the other end of the phone cable into the
LINE-IN port on the rear panel of ComSwitch. |
| 9. |
Plug one end of the second phone cable into
the PHONE port on the rear panel of ComSwitch. |
| 10. |
Plug the other end of the phone cable into
jack "#2." |
| 11. |
Connect the other equipment (fax, computer
modem, answering machine) to the proper corresponding ports. |
|
|
